Genuine FilterQueen Majestic Cellulose Pre-Filter Cones, 12 Pack
This pack includes everything your Majestic needs to maintain powerful cleaning ability and superior filtration for 12 months. When using this pack you receive the following benefits:
- Highest Filtration
- Allergy Relief
- Odor Control
The Majestic Annual Filter Pack includes:
12 Primary Pre-Filter Cones:
This filter must always be used when operating the Majestic. It creates a nearly impenetrable wall against pollutants and protects the life of your Majestic motor.
2 Motor Guards (Flat Disc Filters):
The Motor Guard (Flat Disc Filter) safeguards your Majestic motor to keep it in optimum working condition.
How often to change your filters:
Change at least once a month.
Motor Guard (Flat Disc Filter):
Change every 6 months.
Changing your Majestic filters:
To change the Cones, Medipure Premium Filter Cone or Motor Guard (Flat Disc Filter), watch the instructional video or follow the instructions found below.
Changing the Majestic® Filter Cones
|1. Release side clamps and remove top unit from dirt container.||2. Remove Medipure® Premium Filter Cone and set aside or discard if installing new filter.||3. Empty contents of dirt container and Primary Pre-Filter BioCone™ into a large, open garbage bag.||4. Insert point of a new Primary Pre-Filter BioCone™ into the bottom of the dirt container.||5. Place the Medipure® Premium Filter Cone on top of the Primary Pre-Filter BioCone™.|
|6. Replace top unit and lock side clamps in place. Be sure all three tabs of the Primary Pre-Filter BioCone™ are visible. (Continue with Step 7 if replacing Motor Guard filter.)||7. Remove top unit as shown in Step 1 and then remove the cone guard. It may be necessary to use a Phillips screwdriver for some units.||8. Pull back the plastic retainer ring and lift the ring out. The filter can now be easily removed and discarded.||9. Replace Motor Guard filter. Place the filter over the center section of the screen. Replace retainer ring by squeezing the ring. Make sure the ring snaps into place.||10. Replace the cone guard. Be sure the outer edge of the cone is sealed on the rubber lip around the circumference of the unit. Replace screw if applicable. Replace top unit as shown in Step 6.|
Genuine Filter Check:
You can identify a genuine FilterQueen Filter Cone by locating our FitlerQueen logo and Health-Mor phone number printed on the filter itself. Also, every BioCone has the Genuine FilterQueen Seal printed on it, as shown below.
Find Similar Products by Category
Customers also viewed